FREE BONUS SEEDS WITH ORDERS · DISCREET WORLDWIDE SHIPPING
← Grow guides

How to Germinate Cannabis Seeds: Paper Towel and Water Soak Method, Step by Step

A clean, predictable start sets the tone for the entire run. To break dormancy and push a vigorous taproot, a seed needs just three things: steady warmth, moderate moisture and oxygen. Soggy conditions and cold are the two most common reasons sprouts fail.

Here is a tested two-stage method (water soak + damp paper towels) that takes the guesswork out.

What you need to germinate seeds

  • Filtered or dechlorinated room-temperature water
  • A clean glass
  • Plain, unscented paper towels
  • Two clean plates or a food-safe container with a lid
  • Tweezers (avoid handling seeds with bare fingers to keep bacteria away)

Step 1: Water soak (12–18 hours)

The goal is to soften the shell and wake the embryo up.

  1. Fill a glass with room-temperature water (22–25 °C / 72–77 °F).
  2. Drop your seeds onto the surface.
  3. Put the glass in a warm, dark cupboard for 12–18 hours.
  4. Floating at first is normal. After a few hours, give them a gentle tap with a toothpick; once saturated, they sink.

Step 2: Paper towel method (24–72 hours)

This setup gives the ideal balance: constant moisture with plenty of air.

  1. Wet a sheet of heavy paper towel.
  2. Squeeze it out firmly. It should be damp, not dripping: excess water cuts off oxygen and causes rot.
  3. Lay it on a plate and space the seeds 3–4 cm (1.5 in) apart.
  4. Cover with a second equally damp, well-wrung towel.
  5. Flip a second plate over the top to make a dark, humid chamber.
  6. Keep it somewhere warm and dark at 24–26 °C (75–79 °F). Below 21 °C things slow down; above 29 °C you risk cooking the sprout.
  7. Check once a day. If the towel is drying out, mist it lightly.

Step 3: Planting into medium: taproot direction and depth

The seed is ready when the white taproot has emerged and reached 5–15 mm (0.2–0.6 in). Don't wait for a long root: it snaps easily, and the tiny root hairs tear on contact.

  1. Prep the medium: pre-moisten soil, coco or a starter plug 1–2 hours ahead. It should feel like a wrung-out sponge, never muddy.
  2. Make the hole: 0.5–1 cm (0.2–0.4 in) deep. Plant deeper and the sprout burns its energy before reaching the surface.
  3. Insert the seed: hold it by the shell with tweezers (never touch the white tip) and set it taproot down. Still choosing between soil and coco? See our guide to soil, coco and pot sizes.
  4. Cover lightly: sprinkle loose medium on top. Don't pack it down; the seedling needs air.
  5. Settle it: drizzle 1–2 tablespoons of water around the spot so the medium hugs the seed. Don't soak the whole pot.

Step 4: Seedling care: humidity dome and first light

  • Humidity dome: cover the seedling with a clear cup with a few air holes to hold 70–80% humidity until the first true leaves open.
  • Light: as soon as it breaks the surface, give it gentle light (150–200 PPFD, or a mild LED hung high). In the dark the stem stretches into a weak thread. For day and night targets at every later stage, use our cannabis VPD chart.
  • Remove the dome: 24–48 hours after the round cotyledons open, take the cup off.

Troubleshooting: stuck seed shell and slow germination

  • Shell stuck on the sprout ("helmet"): don't peel it off dry or you'll tear the leaves. Put a drop of water on the shell or dome it for an hour or two, then ease it off with a toothpick once softened.
  • No crack after 4 days: check temperature first; cold below 20 °C is the usual culprit. If it's warm enough and the shell is very thick, lightly scuff the seam with a fine nail file (scarification) and re-moisten.

Quick answers

How long do weed seeds take to germinate?

Usually 1–4 days: a 12–18 hour soak, then 24–72 hours in damp paper towels at 24–26 °C. Older or harder seeds can take a few days longer.

Should seeds germinate in the light or in the dark?

In the dark. Seeds only need warmth, moisture and air. Light is needed once the sprout breaks the surface.

When do I plant a germinated seed, and how deep?

When the white taproot is 5–15 mm long. Plant it taproot down, 0.5–1 cm deep, in pre-moistened medium, and cover it loosely.